Ty-Zon is an excellent product to use in areas where coatings have a tendency of not sticking well to smooth surfaces such as:
a) APP (Atactic Polypropylene) Smooth
b) Asphalt Emulsion
c) EPDM (Ethylene Propylene Diene Monomer)
d) PVC (Poly Vinyl Chloride)
f) Urethane Coatings
Ponderosa’s Galacti-Kote® can be used over Ty-Zon.
All surfaces must be properly cleaned before applying Ty-Zon Primer. All repairs must be made before cleaning is done to insure no interior damage. Power wash the roof surface with clear water.
Before priming make sure surface to be primed is clean and dry. Use only Galacti-Kote® Ty-Zon Primer. This is a water based two-part component epoxy. Part A is the resin portion and part B is the converter.
Step I Mix by volume with moderate agitation, 3 parts component A to1 part component B.
Step II Allow 20 minutes induction time before applying.
Step III Apply a liberal coat with airless spray or roller. Make sure no rain is forecast for 24 hours. One gallon will cover approximately 300 square feet.
Step IV Allow 24 hours curing time. If daytime temperature is greater than 77°F and relative humidity lower than 50 % curing time can be shortened.
Step V Proceed with top coat using Ponderosa’s Galacti-Kote®.
Note: After application of topcoat, adhesion will develop slowly over the next 1-2 weeks, depending on temperature. Do not try to lift topcoat during this time. Pot life is 4-6 hours.